your looking at 270-330 pending where you go for a reco on trade _________________
a real car has 3 pedals
aristo's,rx3 fj20t,urvan z18t,v6 sigma,starion's,la lancer 2.6t aka 4u2no,gc galants
vn/lexcen turbo ,202 six 1200 ute,gh sigma turbo's
escorts,et turbo's,rx7 s3 13b jay port,ta22 celica
That is good. Considering Pedders quoted me $1300.
Now who does trade ins? Covs, Repco?
any decent suspension/cv place should do it pretty cheap.......youll need get you rack done as dont think to many shops would have aristo racks lying around ............pedders are rip off's _________________
a real car has 3 pedals
aristo's,rx3 fj20t,urvan z18t,v6 sigma,starion's,la lancer 2.6t aka 4u2no,gc galants
vn/lexcen turbo ,202 six 1200 ute,gh sigma turbo's
escorts,et turbo's,rx7 s3 13b jay port,ta22 celica
That would be awesome if I could grab that Aristoman
How much do you want for it? How hard are they to change? Could I solo it or would I need help? _________________
That would be awesome if I could grab that Aristoman
How much do you want for it? How hard are they to change? Could I solo it or would I need help?
Looking at $230 for replacement rack. Ive changed two and im a backyarder mechanic, mates chipped in aswell.
Need to undo tie rods and i highly recommend you replace them while you're at it along with balljoints as already stated. Hardest part is dropping the steering because there's not much space to undo the bastid and getting that back in can be painful. Undo lines aswell so be prepared to have fluid dropped on you.
Couple an hour job then you'll need wheel alignment and probally need to reconfigure steering wheel to as the bastid will be out of whack but that's a 10 min job anyway.
Well I have pulled apart the front RHS to change the ball joint and bushes only to discover that the balljoint supplied from the ebay link above are both LHS!!
So my car is in bits, up on stands with no new ball joint to install so angry right now!
On another note: Does anyone know how to get the castor arm that joins to the front LCA out?
The only way I can see it coming out is by removing the whole front subframe/engine crossmember. _________________
Ebay bloke is sending the correct one out asap but I really need them now.
Would you be keen for a swap Jamie? Ie I take you right one now and give you the one I get sent out?
I need it soon as I managed to split the little rubber boot getting mine out _________________
Ebay bloke is sending the correct one out asap but I really need them now.
Would you be keen for a swap Jamie? Ie I take you right one now and give you the one I get sent out?
I need it soon as I managed to split the little rubber boot getting mine out
Im happy to swapover, they'd be from the same joint anyway.
My balljoints part number are: 43330-39455 & 43340-39345.
Anything for you Gabs j/ks..... _________________
WA's Most Powerful 6spd Aristo
The Aristo Spare Parts Man
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
............pedders are rip off's
Yeah that'll work for me fine, get him to bring the set over in anycase to makesure they matchup that's all.
